Dishwasher Installation
New and replacement dishwashers installed level, anchored and leak-tested, with fresh supply, drain and electrical connections.
See the repairDishwashers
Dishwasher repair in Los Angeles for leaks and drain faults
A dishwasher that will not drain or leaks onto the floor needs fast attention. We repair Bosch, Whirlpool, KitchenAid, GE, Samsung, LG, Miele and other dishwashers in your kitchen.
- Phone answered 24/7
- Office in Sun Valley
- Price before the work
$135 to $235 typical for drain clear and filter service
Quick answer
Dishwasher repair usually means clearing or replacing a drain pump, fixing an inlet valve, replacing a door gasket or latch, or repairing a wash motor or control board. If it is leaking, turn off the water valve under the sink and switch off the circuit. Call us any hour, and we give you the price before we begin.
We repair Whirlpool, GE, Samsung, LG, KitchenAid, Bosch, Sub-Zero, Wolf, Thermador and the other names found in Valley kitchens and laundry rooms.
WhirlpoolGESamsungLGFrigidaireKitchenAidMaytagBoschSub-ZeroWolfThermadorVikingKenmoreMiele
Before you call
Safe dishwasher checks before you call
Safe checks only. If anything smells hot, sparks or involves gas, stop and call.
- Remove and rinse the filter at the bottom of the tub under warm running water.
- Run the garbage disposal to clear the shared drain line.
- Check the air gap on the sink deck and clean out any debris.
- Make sure the water valve under the sink is fully open.
- Use dishwasher detergent only, never dish soap, which creates heavy suds and leaks.
Symptoms
Dishwasher problems that need a technician
- Standing water in the tubA clogged filter, a blocked air gap or garbage disposal knockout, or a failed drain pump is usually the cause.
- Leak under the doorA worn door gasket, a cracked spray arm or excess suds can push water out the front.
- Water under the cabinetA failed pump seal, inlet valve or hose clamp leaks out of sight under the tub.
- Dishes come out dirtyWeak spray, a clogged filter or a failing circulation motor leaves food residue.
- Will not startA bad door latch, a blown thermal fuse or a failed control board stops the cycle.
- Dishes stay wetA failed heating element or vent fan leaves dishes wet at the end of the cycle.
The short version
What happens inside a dishwasher cycle
A dishwasher fills through an inlet valve, heats the water, sprays it through the spray arms with a circulation motor, then drains through a pump. A float switch and a pressure sensor stop it from overfilling. A door latch confirms the door is shut before any water enters.
Most dishwasher calls come down to water in the wrong place. Water stays in the tub when the drain pump, filter or air gap is blocked. Water reaches the floor when a gasket, hose, valve or pump seal fails.
Clean results depend on spray pressure, water temperature and a clear filter. When dishes come out gritty, the problem is usually mechanical, not the detergent. A clogged spray arm or a weak motor cannot be fixed by switching brands of pods.
Step by step
Our approach to a dishwasher repair
Every visit follows the same order, so you always know what comes next and what it costs.
Phone us any time
Describe the leak or error and give us the model if you can see it on the door edge.
Drain and inspect
We remove standing water, then check the filter, sump and drain hose.
Run diagnostic mode
We run the test cycle and check each pump, valve and heater in turn.
Explain and price
You get the failed part, the reason and the repair price before work begins.
Full cycle with leak check
We run a full cycle and inspect under the tub for any drips.
Parts and repairs
Dishwasher parts we replace most often
We check the filter and drain path first, then test the pump, valve, heater and latch with a meter. We carry common parts for Bosch, Whirlpool, KitchenAid, Maytag, GE, Frigidaire, Samsung and LG dishwashers.
- Drain pumpPushes water out to the sink drain. Glass shards and seeds jam the impeller.
- Water inlet valveLets water in on command. A scaled or failed valve causes no fill or slow overfill.
- Door gasket and lower sealSeal the door to the tub. Worn seals leak along the floor.
- Door latch and switchTells the control the door is closed. A failed latch stops the cycle from starting.
- Circulation pump and motorDrives spray pressure. A weak motor leaves dishes dirty and makes a humming noise.
- Heating elementHeats water and dries dishes on many models. An open element means cold washes and wet dishes.
- Float switchStops overfilling. A stuck float can stop fill or let the tub flood.
- Control board and touchpadWe read fault codes and test the inputs before replacing electronics.
Los Angeles price ranges
Dishwasher repair prices in Los Angeles
Filter and drain service is the low end. Pumps, valves and latches sit in the middle, while control boards and circulation motors cost the most.
| Repair | Typical range | What moves the price |
|---|---|---|
| Drain clear and filter service | $135 to $235 | Clog location and debris |
| Drain pump replacement | $185 to $345 | Pump design and brand |
| Water inlet valve | $165 to $295 | Valve type and access |
| Door gasket or latch | $145 to $285 | Which part and door design |
| Circulation motor or control board | $295 to $595 | Brand and part availability |
Your real price depends on the part and the diagnosis, and you hear the price before any repair starts.
Here in the Valley
Hard Valley water and what it does to dishwashers
San Fernando Valley water is hard, and dishwashers show it first. Scale coats the heating element, clogs spray arm holes, and leaves the white film on glasses that people often blame on detergent. It also settles in the inlet valve screen and slows fill.
We see scale damage most in dishwashers that run daily without rinse aid. Use rinse aid, clean the filter monthly, and run a dishwasher cleaner every month or two. If your model has a water softener setting or salt reservoir, as many Bosch and Miele models do, we can set it to match local water hardness during the visit.
Worth weighing
Repairing versus replacing a dishwasher
Pumps, valves, latches, gaskets and heaters are worth repairing on most dishwashers under about ten years old. The tub, racks and door are usually fine at that age. A single part replacement often adds years of service.
A rusted tub, a cracked base or a control board on a budget model may push the cost close to a new unit. When that happens, we tell you and give you the price of both options. We also install new dishwashers if replacement is the better choice.
Neighborhoods and ZIP codes
Where we handle dishwasher repair calls
Our Sun Valley office sends technicians across the Valley and the cities around it. These are the places we visit most for dishwasher repair.
- Sun Valley 91352
- North Hollywood 91601
- Valley Village 91607
- Studio City 91604
- Sherman Oaks 91403
- Van Nuys 91405
- Lake Balboa 91406
- Encino 91436
- Tarzana 91356
- Woodland Hills 91364
- West Hills 91307
- Northridge 91324
- Granada Hills 91344
- Porter Ranch 91326
- Chatsworth 91311
- Mission Hills 91345
- Sylmar 91342
- Sunland-Tujunga 91040
- Burbank 91505
- Glendale 91205
- Pasadena 91101
- La Cañada Flintridge 91011
- San Fernando 91340
- Santa Clarita 91355
- Calabasas 91302
- Simi Valley 93065
- Thousand Oaks 91360
Questions
Dishwasher Repair questions we hear in Los Angeles
Why is there standing water in the bottom of my dishwasher?
A clogged filter, a blocked drain hose, a plugged air gap or a failed drain pump keeps water in the dishwasher. A new garbage disposal with the knockout plug still in place can also cause it. We clear the drain path first, then test the pump.
Why is my dishwasher leaking onto the floor?
Leaks under the door usually come from a worn gasket or excess suds. Leaks under the cabinet usually come from the drain pump seal, the inlet valve or a loose hose. Turn off the water and power to the dishwasher and call us to find the source.
Why are my glasses cloudy after the dishwasher runs?
Cloudy glasses are usually hard water film. Rinse aid and a dishwasher cleaner help, and many models have a water hardness setting. If the film remains, the heating element or spray arms may not be working, and we test both during a dishwasher repair visit.
Is it worth repairing a Bosch dishwasher?
In most cases, yes. Bosch dishwashers have durable stainless tubs and commonly need drain pumps, heat pumps or door parts that are reasonable to replace. We check the control board and leak sensor too, since a tripped leak sensor can stop a Bosch dishwasher from running.
Why will my dishwasher not start?
Common causes are a door latch that is not engaging, a child lock or control lock setting, a blown thermal fuse or a failed control board. Check the lock setting and the circuit breaker first. If the dishwasher still will not start, we test the latch and board.
How long does a dishwasher repair take?
Most dishwasher repairs take one to two hours, including the test cycle. If we need to pull the dishwasher out from under the counter for a pump or valve, that adds some time. We carry common parts, so many jobs are finished in one visit.
Also on our list
Related repairs
Garbage Disposal Repair
Garbage disposal repair for jams, humming motors, leaks under the sink and units that trip their reset button.
See the repairAppliance Maintenance
Scheduled appliance maintenance that cleans coils, descales water parts, checks hoses and tests safety parts before they fail.
See the repairSame-Day Appliance Repair
Same-day appliance repair when the schedule allows, with common parts on the van so many fixes finish on the first visit.
See the repairRental Property Appliance Repair
Appliance repair for landlords, property managers and tenants, with access coordinated through the tenant and invoices sent to the owner.
See the repairNeed dishwasher repair today?
Call now. We answer every hour of every day and will tell you what we will check first.