Refrigerator Repair
Warm fresh food section, back-wall frost or nonstop running. We trace the refrigerator fault and repair it at your home.
See the repairAn ice maker that quits usually has a water supply, temperature or control problem, not a dead refrigerator. We sort out which one and get cubes dropping again.

$165 to $310 typical for water inlet valve
Ice maker repair starts by confirming the freezer is cold enough, then testing the water inlet valve, the fill tube, the mold heater, the ejector motor and the shutoff arm or sensor. Check that the ice maker is switched on and the filter is fresh, then call us. We give you the price before we replace any part.
We repair Whirlpool, GE, Samsung, LG, KitchenAid, Bosch, Sub-Zero, Wolf, Thermador and the other names found in Valley kitchens and laundry rooms.
Each harvest cycle follows the same order. The inlet valve opens for a few seconds, water fills the mold, the freezer chills it to about 15°F, and a small heater loosens the cubes so the ejector can push them into the bin. If any one step fails, the bin stays empty.
That is why guessing is expensive. A new ice maker assembly will not help if the inlet valve is clogged or the freezer only reaches 15°F. We test the chain from the water supply forward.
We repair the built-in ice makers in top-freezer, side-by-side and French door refrigerators. We also service standalone undercounter ice machines in kitchens, wet bars and outdoor kitchens. Those machines use their own pumps and valves, and we carry parts for the common models.

Our technician checks freezer temperature, water pressure and voltage at the valve before replacing anything. We carry common ice maker parts for Whirlpool, GE, Samsung, LG, Frigidaire and KitchenAid, plus fill valves for Scotsman and Hoshizaki undercounter machines.


Most ice maker repairs fall in the lower part of what refrigerator work costs. Undercounter clear ice machines run higher because their parts are specialized.
| Repair | Typical range | What moves the price |
|---|---|---|
| Water inlet valve | $165 to $310 | Single or dual valve design |
| Ice maker assembly | $215 to $425 | Brand and in-door versus freezer location |
| Thaw fill tube and reseal | $145 to $255 | Whether a valve leak caused the freeze |
| Auger or dispenser motor | $195 to $360 | Access to the bin and housing |
| Undercounter ice machine repair | $245 to $565 | Pump, valve or control board |
Your real price depends on the part and the diagnosis, and we state that price before we start the work.
Every visit follows the same order, so you always know what comes next and what it costs.
Phone us with the refrigerator or ice machine model and what the ice maker is doing. We give you an arrival window.
We confirm the freezer holds near 0°F, since a warm freezer will not make ice.
We measure water flow at the inlet valve and inspect the filter and fill tube.
We run a forced harvest and test the motor, heater and sensor, then quote the repair.
After the repair, we watch a full fill and harvest cycle to confirm cubes drop.

Backyard pools and outdoor kitchens are common from Calabasas and West Hills to Thousand Oaks and Porter Ranch. When the weather passes 100°F, households go through ice far faster than the ice maker can replace it. People notice a weak ice maker on the first hot weekend of the year.
A refrigerator ice maker produces a limited amount each day, and constant door openings in a hot kitchen cut that output further. If you host often, a dedicated undercounter ice machine in the bar or outdoor kitchen takes the load off the fridge. We repair both, and we can tell you whether your current ice maker is actually failing or simply cannot keep up.
If the refrigerator and freezer hold temperature, an ice maker repair is a small job worth doing. The part is a standalone assembly and replacing it does not affect the rest of the fridge. Most repairs are finished in one visit.
If the freezer is also running warm, fix that first. An ice maker in a 15°F freezer will never harvest correctly, no matter how many parts are replaced. We will tell you which problem is really driving the empty bin.
Safe checks only. If anything smells hot, sparks or involves gas, stop and call.
Our Sun Valley office sends technicians across the Valley and the cities around it. These are the places we visit most for ice maker repair.
The water dispenser and the ice maker often have separate valves or valve coils, so one can work while the other fails. A frozen fill tube is also common. We test the ice maker valve coil, check the tube for ice and confirm the freezer is cold enough.
Expect the first cubes about 12 to 24 hours after the freezer reaches temperature. Throw away the first few batches, since they can carry air and debris from the line. Full bin production on most refrigerator ice makers takes another day or two.
Small or hollow cubes mean the mold is not filling fully. A clogged filter, low household water pressure or a weak inlet valve are the usual causes. We measure the flow at the valve and replace whichever part is restricting it.
Yes. Some Samsung French door models build frost in the door ice compartment when the seal or the compartment fan has trouble. We clear the ice, test the fan and heater, and correct the cause so the ice maker does not keep jamming.
Yes. We repair residential undercounter ice makers from brands such as Scotsman, Hoshizaki, KitchenAid and Sub-Zero. Common repairs include the water valve, the recirculating pump, the drain pump and the cutter grid on clear ice models. We also clean scale off the evaporator plate.
A small drip into the bin is not dangerous, but it will freeze the cubes into a block. Water on the floor is more serious. Turn off the supply valve to the refrigerator, wipe up the water and call us so we can find the leak.
Warm fresh food section, back-wall frost or nonstop running. We trace the refrigerator fault and repair it at your home.
See the repairLeaking supply lines, cracked filter housings and dripping valves behind the fridge. We stop the water and rebuild the connection properly.
See the repairIce machine repair for restaurants, bars and offices: slow harvest, thin ice, scale buildup, leaks and units that stopped making ice.
See the repairUpright, chest and garage freezers that thaw, frost over or will not start. We find the failed part and save your food.
See the repairRepair for built-in grills, outdoor refrigerators, side burners, ice makers and warming drawers that take the full Valley sun.
See the repairCall now. We answer every hour of every day and will tell you what we will check first.